The SEN-1327 LPG Gas Sensor Module is designed to enable LPG detection interface to Microcontroller without ADC Channels. It allows to determine when a preset LPG gas level has been reached or exceeded. Interfacing with the sensor module is done through a 4-pin SIP header and requires One I/O pin from the host microcontroller.
The onboard microcontroller provide initial heating interval after powerup and then starts to meassure LPG sensor output.If it found the LPG contents above setted value, it will inform the Host controller by pulling the Output Pin to High and Starts to blink a onboard status LED. The sensor module is mainly intended to provide a means of comparing LPG sources and being able to set an alarm limit when the source becomes excessive.
SEN1327 pins configuration and photo
SEN-1327 module features
- Uses the MQ-6 LPG Gas Sensor
- Easy SIP interface
- Compatible with most microcontrollers
- Onboard Status and Power LED
- Onboard Pot for threshold setting
- On board microcontroller
No comments:
Post a Comment